10 C.F.R. Appendix D to Part 835—Surface Contamination Values


Title 10 - Energy


Title 10: Energy
PART 835—OCCUPATIONAL RADIATION PROTECTION
Subpart N—Emergency Exposure Situations

Browse Previous |  Browse Next

Appendix D to Part 835—Surface Contamination Values

The data presented in appendix D are to be used in identifying the need for posting of contamination and high contamination areas in accordance with §835.603(e) and (f) and identifying the need for surface contamination monitoring and control in accordance with §§835.1101 and 835.1102.

           Surface Contamination Values \1\ in dpm/100 cm \2\------------------------------------------------------------------------                                                          Total (Fixed +              Radionuclide                 Removable \2\    Removable)                                                \4\          \2\, \3\------------------------------------------------------------------------U-nat, U-235, U-238, and associated            \7\ 1,000       \7\ 5,000 decay products.........................Transuranics, Ra-226, Ra-228, Th-230, Th-             20             500 228, Pa-231, Ac-227, I-125, I-129......Th-nat, Th-232, Sr-90, Ra-223, Ra-224, U-            200           1,000 232, I-126, I-131, I-133...............Beta-gamma emitters (nuclides with decay           1,000           5,000 modes other than alpha emission or spontaneous fission) except Sr-90 and others noted above \5\.................Tritium and tritiated compounds \6\.....          10,000             N/A------------------------------------------------------------------------\1\ The values in this appendix, with the exception noted in footnote 5,  apply to radioactive contamination deposited on, but not incorporated  into the interior or matrix of, the contaminated item. Where surface  contamination by both alpha-and beta-gamma-emitting nuclides exists,  the limits established for alpha-and beta-gamma-emitting nuclides  apply independently.\2\ As used in this table, dpm (disintegrations per minute) means the  rate of emission by radioactive material as determined by correcting  the counts per minute observed by an appropriate detector for  background, efficiency, and geometric factors associated with the  instrumentation.\3\ The levels may be averaged over one square meter provided the  maximum surface activity in any area of 100 cm \2\ is less than three  times the value specified. For purposes of averaging, any square meter  of surface shall be considered to be above the surface contamination  value if: (1) From measurements of a representative number of sections  it is determined that the average contamination level exceeds the  applicable value; or (2) it is determined that the sum of the activity  of all isolated spots or particles in any 100 cm \2\ area exceeds  three times the applicable value.\4\ The amount of removable radioactive material per 100 cm \2\ of  surface area should be determined by swiping the area with dry filter  or soft absorbent paper, applying moderate pressure, and then  assessing the amount of radioactive material on the swipe with an  appropriate instrument of known efficiency. (Note_The use of dry  material may not be appropriate for tritium.) When removable  contamination on objects of surface area less than 100 cm \2\ is  determined, the activity per unit area shall be based on the actual  area and the entire surface shall be wiped. It is not necessary to use  swiping techniques to measure removable contamination levels if direct  scan surveys indicate that the total residual surface contamination  levels are within the limits for removable contamination.\5\ This category of radionuclides includes mixed fission products,  including the Sr-90 which is present in them. It does not apply to Sr-  90 which has been separated from the other fission products or  mixtures where the Sr-90 has been enriched.\6\ Tritium contamination may diffuse into the volume or matrix of  materials. Evaluation of surface contamination shall consider the  extent to which such contamination may migrate to the surface in order  to ensure the surface contamination value provided in this appendix is  not exceeded. Once this contamination migrates to the surface, it may  be removable, not fixed; therefore, a ``Total'' value does not apply.\7\ (alpha)

[58 FR 65485, Dec. 14, 1993, as amended at 63 FR 59688, Nov. 4, 1998]

Browse Previous |  Browse Next









































































chanrobles.com