30 C.F.R. § 56.9300 Berms or guardrails.
Title 30 - Mineral Resources
(a) Berms or guardrails shall be provided and maintained on the banks of roadways where a drop-off exists of sufficient grade or depth to cause a vehicle to overturn or endanger persons in equipment. (b) Berms or guardrails shall be at least mid-axle height of the largest self-propelled mobile equipment which usually travels the roadway. (c) Berms may have openings to the extent necessary for roadway drainage. (d) Where elevated roadways are infrequently traveled and used only by service or maintenance vehicles, berms or guardrails are not required when all of the following are met: (1) Locked gates are installed at the entrance points to the roadway. (2) Signs are posted warning that the roadway is not bermed. (3) Delineators are installed along the perimeter of the elevated roadway so that, for both directions of travel, the reflective surfaces of at least three delineators along each elevated shoulder are always visible to the driver and spaced at intervals sufficient to indicate the edges and attitude of the roadway. (4) A maximum speed limit is posted and observed for the elevated unbermed portions of the roadway. Factors to consider when establishing the maximum speed limit shall include the width, slope and alignment of the road, the type of equipment using the road, the road material, and any hazardous conditions which may exist. (5) Road surface traction is not impaired by weather conditions, such as sleet and snow, unless corrective measures are taken to improve traction. (e) This standard is not applicable to rail beds. [53 FR 32520, Aug. 25, 1988, as amended at 55 FR 37218, Sept. 7, 1990]
Title 30: Mineral Resources
PART 56—SAFETY AND HEALTH STANDARDS—SURFACE METAL AND NONMETAL MINES
Subpart H—Loading, Hauling, and Dumping
Safety Devices, Provisions, and Procedures for Roadways, Railroads, and Loading and Dumping Sites
§ 56.9300 Berms or guardrails.
