46 C.F.R. § 52.01-140 Certification by stamping (modifies PG–104 through PG–113).
Title 46 - Shipping
(a) All boilers built in accordance with this part must be stamped with the appropriate ASME Code symbol as required by PG–104 through PG–113 of the ASME Code. (b)(1) Upon satisfactory completion of the tests and Coast Guard inspections, boilers must be stamped with the following: (i) Manufacturer's name and serial number; (ii) ASME Code Symbol; (iii) Coast Guard symbol, which is affixed only by marine inspector (see §50.10–15 of this subchapter); (iv) Maximum allowable working pressure ___ at ___ °C (°F): and (v) Boiler rated steaming capacity in kilograms (pounds) per hour (rated joules (B.T.U.) per hour output for high temperature water boilers). (2) The information required in paragraph (b)(1) of this section must be located on: (i) The front head or shell near the normal waterline and within 610 mm (24 inches) of the front of firetube boilers; and (ii) The drum head of water tube boilers. (3) Those heating boilers which are built to section I of the ASME Code, as permitted by §53.01–10(e) of this subchapter, do not require Coast Guard stamping and must receive full ASME stamping including the appropriate code symbol. (c) The data shall be legibly stamped and shall not be obliterated during the life of the boiler. In the event that the portion of the boiler upon which the data is stamped is to be insulated or otherwise covered, a metal nameplate as described in PG–106.6 of the ASME Code shall be furnished and mounted. The nameplate is to be maintained in a legible condition so that the data may be easily read. (d) Safety valves shall be stamped as indicated in PG–110 of the ASME Code. [CGD 81–79, 50 FR 9433, Mar. 8, 1985]
Title 46: Shipping
PART 52—POWER BOILERS
Subpart 52.01—General Requirements
§ 52.01-140 Certification by stamping (modifies PG–104 through PG–113).
