46 C.F.R. § 107.235 Servicing of hand portable fire extinguishers, semi-portable fire extinguishers and fixed fire-extinguishing systems.
Title 46 - Shipping
(a) Each hand portable fire extinguisher and each semi-portable fire extinguisher on board the unit must be serviced as set out in Table 107.235 and examined for excessive corrosion and general condition. (b) Each fixed fire-extinguishing system must be examined for excessive corrosion and general condition and be serviced by— (1) Recharging the cylinders of each carbon dioxide system, if the weight loss is more than 10% of the weight of the charge; (2) Testing each foam system, except premix systems by— (i) Discharging foam for approximately 15 seconds from a nozzle designated by the marine inspector; (ii) Discharging water from all other lines and nozzles; and (iii) Taking a sample of the foam liquid and submitting it to the manufacturer or his authorized representative for determination of its specific gravity, PH, percentage of water dilution, and solid content, and certification as a suitable firefighting foam; (3) Removing the pressure cartridge of each premix aqueous film forming foam system and replacing the cartridge if the seal is punctured, sampling the premix solution in accordance with the manufacturer's instructions, and replacing cylinders that are discharged. Note: All carbon dioxide cylinders and discharge hoses of semi-portable carbon dioxide and halon extinguishers must be tested and marked in accordance with §§147.60 and 147.65 of this chapter. [CGD 73–251, 43 FR 56802, Dec. 4, 1978, as amended by CGD 84–044, 53 FR 7749, Mar. 10, 1988]
Title 46: Shipping
PART 107—INSPECTION AND CERTIFICATION
Subpart B—Inspection and Certification
§ 107.235 Servicing of hand portable fire extinguishers, semi-portable fire extinguishers and fixed fire-extinguishing systems.
Table 107.235------------------------------------------------------------------------ Type extinguisher Test and servicing required------------------------------------------------------------------------Soda Acid...................... Discharge, clean hose and inside of extinguisher thoroughly. Recharge.Foam........................... Discharge, clean hose and inside of extinguisher thoroughly. Recharge.Pump Tank (water or antifreeze) Discharge, clean hose and inside of extinguisher thoroughly. Recharge with clean water or antifreeze.Cartridge operated (water, Examine pressure cartridge and replace antifreeze or loaded stream). if end is punctured or if cartridge is otherwise determined to have leaked or to be in unsuitable condition. Remove liquid, clean hose and inside of extinguisher thoroughly. Recharge with clean water, solution, or antifreeze. Insert charged cartridge.Carbon Dioxide................. Weigh cylinders. Recharge if weight loss exceeds 10 percent. Inspect hose and nozzle to be sure they are clear.Dry chemical (cartridge- Examine pressure cartridge and replace operated type). if end is punctured or if cartridge is otherwise determined to have leaked or to be in unsuitable condition. Inspect hose and nozzle to see if they are clear. Insert charged cartridge. Be sure dry chemical is free-flowing (not caked) and chamber contains full charge.Dry chemical (stored pressure See that pressure gage is in operating type). range. If not, or if seal is broken, weigh or otherwise determine that full charge of dry chemical is in extinguisher. Recharge if pressure is low or if dry chemical is needed.------------------------------------------------------------------------
