46 C.F.R. § 111.70-3 Motor controllers and motor control centers.
Title 46 - Shipping
(a) General. The enclosure for each motor controller or motor control center must meet NEMA No. ICS 2 and NEMA No. 2.3 1983 or meet Table 5 of IEC 92–201, as appropriate, for the location where it is installed. In addition, each enclosure in a hazardous location must meet subpart 111.105 of this part. NEMA No. 2.4 provides guidance on the differences between NEMA and IEC devices for motor service. (b) Low-voltage release. Each motor controller for a fire pump, elevator, steering gear, or auxiliary that is vital to the vessel's propulsion system, except a motor controller for a vital propulsion auxiliary which can be restarted from a central control station, must have low-voltage release if automatic restart after a voltage failure or its resumption to operation is not hazardous. If automatic restart is hazardous, the motor controller must have low-voltage protection. Motor controllers for other motors must not have low-voltage release unless the starting current and the short-time sustained current of the additional low-voltage release load is within the capacity of one ship's service generator. Automatic sequential starting of low-voltage release controllers is acceptable to meet this paragraph. (c) Low-voltage protection. Each motor controller must have low-voltage protection, except for the following motor controllers: (1) A motor controller that has low-voltage release under paragraph (b) of this section. (2) A motor controller for a motor of less than 2 horsepower (1.5 kW). (d) Identification of controllers. (1) Each motor controller and motor control center must be marked externally with the following information: (i) Manufacturer's name or identification. (ii) Voltage. (iii) Number of phases. (iv) Current. (v) kW (Horsepower). (vi) Identification of motor being controlled. (vii) Current rating of trip setting. (2) Each controller must be provided with heat durable and permanent elementary wiring/schematic diagrams of the controller located on the door interior. [CGD 94–108, 61 FR 28281, June 4, 1996; 61 FR 33045, June 26, 1996]
Title 46: Shipping
PART 111—ELECTRIC SYSTEMS—GENERAL REQUIREMENTS
Subpart 111.70—Motor Circuits, Controllers, and Protection
§ 111.70-3 Motor controllers and motor control centers.
