47 C.F.R. § 2.947 Measurement procedure.
Title 47 - Telecommunication
(a) The Commission will accept data which have been measured in accordance with the following standards or measurement procedures: (1) Those set forth in bulletins or reports prepared by the Commission's Office of Engineering and Technology. These will be issued as required, and specified in the particular part of the rules where applicable. (2) Those acceptable to the Commission and published by national engineering societies such as the Electronic Industries Association, the Institute of Electrical and Electronic Engineers, Inc., and the American National Standards Institute. (3) Any measurement procedure acceptable to the Commission may be used to prepare data demonstrating compliance with the requirements of this chapter. (b) Information submitted pursuant to paragraph (a) of this section shall completely identify the specific standard or measurement procedure used. (c) In the case of equipment requiring measurement procedures not specified in the references set forth in paragraphs (a) (1) and (2) of this section, the applicant shall submit a detailed description of the measurement procedures actually used. (d) A listing of the test equipment used shall be submitted. (e) If deemed necessary, the Commission may require additional information concerning the measurement procedures employed in obtaining the data submitted for equipment authorization purposes. [42 FR 44987, Sept. 8, 1977, as amended at 44 FR 39181, July 5, 1979; 51 FR 12616, Apr. 14, 1986]
Title 47: Telecommunication
PART 2—FREQUENCY ALLOCATIONS AND RADIO TREATY MATTERS; GENERAL RULES AND REGULATIONS
Subpart J—Equipment Authorization Procedures
Conditions Attendant to an Equipment Authorization
§ 2.947 Measurement procedure.
