49 C.F.R. § 171.14 Transitional provisions for implementing certain requirements.
Title 49 - Transportation
General. The purpose of the provisions of this section is to provide an orderly transition to certain new requirements so as to minimize any burdens associated with them. (a) Previously filled packages—(1) Packages filled prior to October 1, 1991. Notwithstanding the marking and labeling provisions of subparts D and E, respectively, of part 172, and the packaging provisions of part 173 and subpart B of part 172 of this subchapter, a package may be offered for transportation and transported prior to October 1, 2001, if it— (i) Conforms to the old requirements of this subchapter in effect on September 30, 1991; (ii) Was filled with a hazardous material prior to October 1, 1991; (iii) Is marked “Inhalation Hazard” if appropriate, in accordance with §172.313 of this subchapter or Special Provision 13, as assigned in the §172.101 table; and (iv) Is not emptied and refilled on or after October 1, 1991. (2) Non-bulk packages filled prior to October 1, 1996. Notwithstanding the packaging provisions of subpart B of part 172 and the packaging provisions of part 173 of this subchapter with respect to UN standard packagings, a non-bulk package other than a cylinder may be offered for transportation and transported domestically prior to October 1, 1999, if it— (i) Conforms to the requirements of this subchapter in effect on September 30, 1996; (ii) Was filled with a hazardous material prior to October 1, 1996; and (iii) Is not emptied and refilled on or after October 1, 1996. (b) Transitional placarding provisions. Until October 1, 2001, placards which conform to specifications for placards in effect on September 30, 1991, or placards specified in the December 21, 1990 final rule may be used, for highway transportation only, in place of the placards specified in subpart F of part 172 of this subchapter, in accordance with the following table: (c) Non-specification fiber drums. A non-specification fiber drum with a removable head is authorized for a liquid hazardous material in Packing Group III that is not poisonous by inhalation for which the packaging was authorized under the requirements of part 172 or part 173 of this subchapter in effect on September 30, 1991. This authorization expires on the date on which funds are authorized to be appropriated to carry out chapter 51 of title 49, United States Code (related to transportation of hazardous materials), for fiscal years beginning after September 30, 1997. Information concerning this funding authorization date may be obtained by contacting the Office of the Associate Administrator. (d) A final rule published in the (1) Transition dates. The effective date of the final rule published on December 20, 2004, is January 1, 2005. A delayed compliance date of January 1, 2006 is authorized. On and after January 1, 2006, all applicable regulatory requirements adopted in the final rule in effect on January 1, 2005 must be met. (2) Intermixing old and new requirements. Marking, labeling, placarding, and shipping paper descriptions must conform to either the old requirements of this subchapter in effect on December 31, 2004, or the new requirements of this subchapter in the final rule without intermixing communication elements, except that intermixing is permitted, during the applicable transition period, for packaging, hazard communication, and handling provisions, as follows: (3) [Reserved] (4) Until January 1, 2010, a hazardous material may be transported in an IM, IMO, or DOT Specification 51 portable tank in accordance with the T Codes (Special Provisions) assigned to a hazardous material in Column (7) of the §172.101 Table in effect on September 30, 2001. (5) Proper shipping names that included the word “inhibited” prior to the June 21, 2001 final rule in effect on October 1, 2001 are authorized on packagings and shipping papers in place of the word “stabilized” until October 1, 2007. Proper shipping names that included the word “compressed” prior to the final rule published on July 31, 2003 and effective on October 1, 2003 may continue to be shown on packagings and shipping papers until October 1, 2007. (6) Section 172.202(a)(6) requires the number and types of packages to be indicated on shipping papers. Until October 1, 2007, a person may elect to comply with the requirements for the number and type of packages in effect on September 30, 2003. (7) Except for transport by vessel, the non-mandatory shipping paper provision to include the subsidiary hazard class or division number in accordance with §172.202(a)(2), in effect on September 30, 2003, is authorized until October 1, 2005. (8) Until October 1, 2005, proper shipping names that did not identify specific isomers by numbers or letters preceding the chemical name prior to the final rule published on July 31, 2003 and effective on October 1, 2003, may continue to be marked on packagings and are authorized on shipping papers in place of the proper shipping names revised in the July 31, 2003 final rule. (e) A Division 6.2 label conforming to specifications in §172.432 of this subchapter in effect on September 30, 2002, may be used until October 1, 2005. (f) 49 CFR 175.33 sets out requirements regarding the availability of information for hazardous materials transported by aircraft. Until April 1, 2005, a person may elect to comply with either the applicable requirements of 49 CFR 175.33 in effect on September 30, 2003, and contained in 49 CFR Part 175 revised as of October 1, 2002, or the requirements of that section contained in 49 CFR Part 175 revised as of October 1, 2003. On April 1, 2005, all applicable regulatory requirements in 49 CFR 175.33 in effect on October 1, 2003 must be met. [Amdt. 171–131, 59 FR 67406, Dec. 29, 1994] Editorial Note: For
Title 49: Transportation
PART 171—GENERAL INFORMATION, REGULATIONS, AND DEFINITIONS
§ 171.14 Transitional provisions for implementing certain requirements.
Placard Substitution Table------------------------------------------------------------------------ Current placard Old (Sept. 30, 1991) Hazard class or division No. name placard name------------------------------------------------------------------------Division 1.1................. Explosives 1.1. Explosives A.Division 1.2................. Explosives 1.2. Explosives A.Division 1.3................. Explosives 1.3. Explosives B.Division 1.4................. Explosives 1.4. Dangerous.Division 1.5................. Explosives 1.5. Blasting agents.Division 1.6................. Explosives 1.6. Dangerous.Division 2.1................. Flammable gas.. Flammable gas.Division 2.2................. Nonflammable Nonflammable gas. gas.Division 2.3\1\.............. Poison gas..... Poison gas.Class 3...................... Flammable...... Flammable.Combustible liquid........... Combustible.... Combustible.Division 4.1................. Flammable solid Flammable solid.Division 4.2................. Spontaneously Flammable solid. combustible.Division 4.3................. Dangerous when Flammable solid W. wet.Division 5.1................. Oxidizer....... Oxidizer.Division 5.2................. Organic Organic peroxide. peroxide.Division 6.1, (inhalation Poison Poison. hazard, Zone A or B)\1\. inhalation hazard.Division 6.1, PG I (other Posion......... Poison. than Zone A or B inhalation hazard), PG II, or PG III.Class 7...................... Radioactive.... Radioactive.Class 8...................... Corrosive...... Corrosive.Class 9...................... Class 9........ (none required).------------------------------------------------------------------------\1\ For materials poisonous by inhalation, by all modes of transportation, until October 1, 2001, placards may be used that conform to specifications for placards (1) in effect on September 30, 1991, (2) specified in the December 21, 1990 final rule, or (3) specified in the July 22, 1997 final rule.
