50 C.F.R. § 654.22 Gear restrictions.
Title 50 - Wildlife and Fisheries
(a) Trap construction requirements. No person fishing for stone crab may transport on the water or fish with any trap which does not meet the following requirements: (1) Each trap must be constructed of wood, plastic, or wire. (2) A trap may be no larger in dimension than 24 by 24 by 24 inches (61 by 61 by 61 cm) or 8.0 ft3 (0.23 m3 ). (3) The throats (entrances) to all wood and plastic traps must be located on the top horizontal section of the trap. If the throat is longer in one dimension, the throat size in the longer dimension must not exceed 5 (4) In any wire trap used to harvest stone crabs, each throat must be horizontally oriented. The width of the opening where the throat meets the vertical wall of the trap and the opening of the throat at its farthest point from the vertical wall, inside the trap, must be greater than the height of any such opening. No such throat may extend farther than 6 inches (15.2 cm) into the inside of any trap, measured from where the throat opening meets the vertical wall of the trap to the throat opening at its farthest point from the vertical wall, inside the trap. (5) A wire trap must have at least three unobstructed escape rings installed, each with a minimum inside diameter of 2 (6) A plastic or wire trap must have a degradable panel. (i) A plastic trap will be considered to have degradable panel if it contains at least one sidewall with a rectangular opening no smaller in either dimension than that of the throat. This opening may be obstructed only with a cypress or untreated pine slat or slats no thicker than (ii) A wire trap will be considered to have a degradable panel if one of the following methods is used in construction of the trap: (A) The trap lid tie-down strap is secured to the trap at one end by a single loop of untreated jute twine, a corrodible loop composed of non-coated steel wire measuring 24 gauge or thinner, or an untreated pine dowel no larger than 2 inches (5.1 cm) in length by (B) The trap contains at least one sidewall with a vertical rectangular opening no smaller in either dimension than 6 inches (15.2 cm) in height by 3 inches (7.6 cm) in width. This opening may be laced, sewn, or otherwise obstructed by— (1) A single length of untreated jute twine knotted only at each end and not tied or looped more than once around a single mesh bar; (2) Untreated pine slat(s) no thicker than (3) Non-coated steel wire measuring 24 gauge or thinner; (4) A panel of ferrous single-dipped galvanized wire mesh made of 24 gauge or thinner wire; or (5) A rectangular panel made of any material, fastened to the trap at each of the four corners of the rectangle by rings made of non-coated 24 gauge or thinner wire or single strands of untreated jute twine. When the jute, untreated pine slat(s), non-coated steel wire, wire mesh panel, or corner fasteners degrade, the opening in the sidewall of the trap must no longer be obstructed. (b) Daylight hours. A stone crab trap in the management area may be pulled or tended during daylight hours only—that is, from 1 hour before sunrise to 1 hour after sunset. (c) Gear belonging to others. No fisherman may willfully tend, open, pull, or otherwise molest another fisherman's trap, buoy, or line in the management area without the prior written consent of that fisherman. [60 FR 13919, Mar. 15, 1995, as amended at 65 FR 31835, May 19, 2000]
Title 50: Wildlife and Fisheries
PART 654—STONE CRAB FISHERY OF THE GULF OF MEXICO
Subpart B—Management Measures
§ 654.22 Gear restrictions.
