14 C.F.R. § 23.397 Limit control forces and torques.
Title 14 - Aeronautics and Space
(a) In the control surface flight loading condition, the airloads on movable surfaces and the corresponding deflections need not exceed those that would result in flight from the application of any pilot force within the ranges specified in paragraph (b) of this section. In applying this criterion, the effects of control system boost and servo-mechanisms, and the effects of tabs must be considered. The automatic pilot effort must be used for design if it alone can produce higher control surface loads than the human pilot. (b) The limit pilot forces and torques are as follows: [Doc. No. 4080, 29 FR 17955, Dec. 18, 1964, as amended by Amdt. 23–7, 34 FR 13089, Aug. 13, 1969; Amdt. 23–17, 41 FR 55464, Dec. 20, 1976; Amdt. 23–34, 52 FR 1829, Jan. 15, 1987; Amdt. 23–45, 58 FR 42160, Aug. 6, 1993]
Title 14: Aeronautics and Space
PART 23—AIRWORTHINESS STANDARDS: NORMAL, UTILITY, ACROBATIC, AND COMMUTER CATEGORY AIRPLANES
Subpart C—Structure
Control Surface and System Loads
§ 23.397 Limit control forces and torques.
------------------------------------------------------------------------ Maximum forces or torques for design weight, weight Minimum forces or Control equal to or less torques \2\ than 5,000 pounds \1\------------------------------------------------------------------------Aileron: Stick......................... 67 lbs............ 40 lbs. Wheel \3\..................... 50 D in.-lbs \4\.. 40 D in.-lbs.\4\Elevator: Stick......................... 167 lbs........... 100 lbs. Wheel (symmetrical)........... 200 lbs........... 100 lbs. Wheel (unsymmetrical) \5\..... .................. 100 lbs.Rudder.......................... 200 lbs........... 150 lbs.------------------------------------------------------------------------\1\ For design weight (W) more than 5,000 pounds, the specified maximum values must be increased linearly with weight to 1.18 times the specified values at a design weight of 12,500 pounds and for commuter category airplanes, the specified values must be increased linearly with weight to 1.35 times the specified values at a design weight of 19,000 pounds.\2\ If the design of any individual set of control systems or surfaces makes these specified minimum forces or torques inapplicable, values corresponding to the present hinge moments obtained under § 23.415, but not less than 0.6 of the specified minimum forces or torques, may be used.\3\ The critical parts of the aileron control system must also be designed for a single tangential force with a limit value of 1.25 times the couple force determined from the above criteria.\4\ D=wheel diameter (inches).\5\ The unsymmetrical force must be applied at one of the normal handgrip points on the control wheel.
