---

16 C.F.R. § 309.20   Labeling requirements for new covered vehicles.

Title 16 - Commercial Practices

Title 16: Commercial Practices
PART 309—LABELING REQUIREMENTS FOR ALTERNATIVE FUELS AND ALTERNATIVE FUELED VEHICLES
Subpart C—Requirements for Alternative Fueled Vehicles

Browse Next

§ 309.20   Labeling requirements for new covered vehicles.

(a) Affixing and maintaining labels. (1) Before offering a new covered vehicle for acquisition to consumers, manufacturers shall affix or cause to be affixed, and new vehicle dealers shall maintain or cause to be maintained, a new vehicle label on a visible surface of each such vehicle.

(2) If an aftermarket conversion system is installed on a vehicle by a person other than the manufacturer prior to such vehicle's being acquired by a consumer, the manufacturer shall provide that person with the vehicle's estimated cruising range (as determined by §309.22(a) for dedicated vehicles and §309.22(b) for dual fueled vehicles) and ensure that new vehicle labels are affixed to such vehicles as required by paragraph (a) of this section.

(b) Layout. Figures 4, 5, and 5.1 are prototype labels that demonstrate the proper layout. All positioning, spacing, type size, and line widths shall be similar to and consistent with the prototype labels. Labels required by this section are one-sided and rectangular in shape measuring 7 inches (17.78 cm) wide and 71/2 inches (19.05 cm) long. Figure 4 of appendix A represents the prototype for the labels for dedicated vehicles. Figures 5 and 5.1 of appendix A represent the prototype of the labels for dual-fueled vehicles; Figure 5 of appendix A represents the prototype for vehicles with one fuel tank and Figure 5.1 of appendix A represents the prototype for vehicles with two fuel tanks. No marks or information other than that specified in this subpart shall appear on this label except that the label may include part numbers, bar codes, and vehicle identification numbers consistent with Figures 4, 5, and 5.1.

(c) Type size and setting. The Helvetica Condensed and Helvetica family typefaces or equivalent shall be used exclusively on the label. Specific type sizes and faces to be used are indicated on the prototype labels (Figures 4, 5, and 5.1 of appendix A). No hyphenation should be used in setting headline or text copy. Positioning and spacing should follow the prototypes closely.

(d) Colors and Paper Stock. All labels shall be printed in process black ink on Hammermill Offset Opaque Vellum/S.70 Sky Blue (or equivalent) paper.

(e) Content. (1) Headlines and text, as illustrated in Figures 4, 5, and 5.1 of appendix A, are standard for all labels.

(2) Estimated cruising range. (i) For dedicated vehicles, determined in accordance with §309.22(a).

(ii) For dual fueled vehicles, determined in accordance with §309.22(b).

[69 FR 55338, Sept. 14, 2004]

Browse Next